George Lendich wrote:

In your case you need to make it as thin as possible. Except where
the rubber bushings go. See the Barry drawings I just sent on that.
Gusset it top and bottom.

Paul Lamar

Paul,
Will it need to be thicker where the bolts go through.
George (down under)

A little won't hurt say 10 mm thick and 20 mm dia. Keep the bolts
as close to the four corners as possible. Four 8 mm bolts are fine.
Use hex socket head bolts and you can get them closer to the corners.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.