George Lendich wrote:

George your damper design looks too complicated.

All you need are a 10 mm ID titanium spacer in the center of the rubber
bushing and a large washer to capture the rubber.
Don't scale my sketch! You will have to beef up the auto tx flex
plate where the 10 mm cantilevered titanium bolt is attached.

Paul,
Weld on a large thick mild steel washer, say 2" wide by 1/8" thick, to
beef-up the plate, is that over kill ?

Should the flex-plate with output plate and rubbers be balanced ?
George (down under)

No not overkill won't hurt.

By all means on the balance.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.