George Lendich wrote:

Paul,
Progress Report.

Well I've been busy sanding those MM sides square after filling and sanding the stiffeners to fit the housing.

This a real tedious job and so will  be fitting them as there needs to be a taper on them and they need to be dead square to the
face, otherwise they will hang-up on the walls of the mould. This is going to be areal pain !!

I've put a bend on the bottom of the lower left and right stiffeners so that the lower part is parallel to the centre stiffener.
I hope you can understand this - it's hard to explain.

Keeping going!!
George (down under)

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.