Subject: Question about tension and threaded tubing.
From: ACRE
Date: 7/11/2003, 9:22 PM


I agree with Paul, Cutting threads is always bad. The best alternitive if you must thread a tube is to contain the outside and then use a roll of forming tap. The form tap doesn't cut the tube it forges the thread. The tube will still be reduced in strength, but at least wont have the built in cracks
caused by cutting. SORRY I DIDN'T SIGN THIS Bill Jepson


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.