Subject: Question about tension and threaded tubing.
From: ACRE
Date: 7/11/2003, 9:23 PM


Yes.
However much worse than that. You now have a bunch of built in
cracks.
If there are any sort of cyclical loads it is almost
guaranteed to fail.

I agree with Paul, Cutting threads is always bad. The best alternitive
if you must thread a tube is to contain the outside and then use a roll
of forming tap. The form tap doesn't cut the tube it forges the thread.
The tube will still be reduced in strength, but at least wont have the
built in cracks caused by cutting.


How do you keep a rotor shaft or prop hub (in a PSRU) from pulling out?
My "Evans Handbook" is lacking with this type of info. :)

Different situation. The shafts are almost solid.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.