Paul,
Revising the mounting hole position I have a discrepancy on position 131 degrees,
one drawings shows 131-13' 46" the other(Tracy's), 131- 58' 46"

position 226 degrees,
one drawings 226 -12' 26"- Tracy's 226 - 5' 56"

From the looks of it the first set of figures they might be typos as they reflect the figures above.

Question would that affect the co-ordinates shown in one drawing and should I accept that Tracy's is accurate - it would seem so
!!

I checked the degrees as best I could with the equipment I have, but those fine differences are beyond me.I just want to get it
right before I hand it over to the machinist.
George (down under)

Tracy could you check those numbers for us?

Paul Lamar

I guess Tracy did not get the message.
I suggest you drill the holes in a piece of plywood and offer it up
to an end housing to check and see if the holes are in the right position.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.