The 3rd gen is such that the ports are higher up on the block, There is no way I can get the tubes down that low.
...Chrissi

Yes I can belive that. I forgot. Are you using the tube bends I sent or are you using the
two inch inside radius RB Wagner pipe bends?

Paul Lamar

Using the recommended RB wagner bends.
...Chrissi

That is about the best you can do. You could cheat a bit and mill some off 
the top of the manifold casting. Are you really that pressed for overall engine
height on the Cozy?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.