Paul,
here is the photo that I referred to where I had to grind the corners to clear the manifold injectors.
Bill Schertz
KIS Cruiser # 4045

The 3rd gen is such that the ports are higher up on the block, There is no way I can get the tubes down that low.
...Chrissi

Yes I can belive that. I forgot. Are you using the tube bends I sent or are you using the 
two inch inside radius RB Wagner pipe bends?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.