Bill Schertz, you mentioned your front  injector holder protruded
through the cowl surface on the Kis Cruiser.
Did you saw this oil Filter holder off and plug the holes
with pipe plugs? It is preventing my intake manifold from laying
right down on the top of the engine.

I am going to fill the oil passage holes with candle wax before I saw it

off

to prevents the  iron particles from getting into the oil galleries.
I will then use a small magnet to remove the iron particles them from the

wax.

If any wax gets into the oil system it will probably melt and be

dissipated

in the oil. Hopefully.

Paul Lamar

Paul,
My engine was built up by Bruce Turrentine, and he had machined off the Oil
filter holder and plugged the holes. I had to grind off a couple of corners
of the cast iron to get it to lie down . Included in some of the pictures I
sent to you.
Bill

OK Thanks Bill.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.