Bob Darrah wrote:

Paul,

Mayby I am not understanding your test system right, but if the pipe that
goes out the top is basicly a "stand pipe", it looks to me as if you are
restricting the intake, not the     output of the pump

By putting the "stand pipe" in the lower tube, it would flod the intake and
the valve would restrict the output.

So you had trouble with those circuit breakers, too.

FWIW

Bob Darrah

In theory in a sealed closed loop water system water speeds up when it goes
through a restrictor and slow down when it encounters a larger
pipe. Total volume of flow is the same. In theory the inlet is always 
flooded. Liquid is not compressible. This differs greatly from a gas. 
With a gas volume goes  down while pressure goes up. It can be argued that coolant
is a combination of liquid and gas. The gas is dissolved and is released
when the coolant is heated I suspect. I could be wrong about that.
I think Bill can fill (sorry, no pun intended.) us in on this.

The stand pipe is capped and sealed so I can pressurize the system.
If it were not sealed it is only about a foot high so the resulting pressure 
on the outlet and on the entire rest of the system would only be about .45 psi. 

Re: circuit breakers. We all agree. Pumping water takes HP!!!

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.