Subject: Failed water pump pulley.
From: ACRE
Date: 7/14/2003, 4:23 PM


If  they are tapered, then the housing area could be turned to establish
a
smooth surface, no notch.  The bearing can then sit on a ring that has a
wedge
shaped cross section to match the housing.  The bearing can be held in
place by
the interior shape of the pulley, and if the bearing is flanged-it would
keep
the ring in place.

The dia of the pulley is increased, which would slow down the pump, (not
so
good).

Of course if there is no taper, a lot of the work goes away.

Joe Graham

Joe,
Good point on the stress riser, I initially threw in the idea just as food
for thought, not knowing the area restrictions - however it appears you have
given it considerable thought. To me it's a simple solution that solves a
potential failure problem and with Paul actually doing the mouldings - it's
a made to order item. I hope he takes it up.
George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.