Subject: Failed water pump pulley.
From: ACRE
Date: 7/14/2003, 11:02 AM


Sorry George,  it must have been before my time.

A couple of more thoughts.  If the housing is/are tapered,  to notch it for
the bearing to sit on may create a stress riser.  Big mistake.

If  they are tapered, then the housing area could be turned to establish a
smooth surface, no notch.  The bearing can then sit on a ring that has a wedge
shaped cross section to match the housing.  The bearing can be held in place by
the interior shape of the pulley, and if the bearing is flanged-it would keep
the ring in place.

The dia of the pulley is increased, which would slow down the pump, (not so
good).

Of course if there is no taper, a lot of the work goes away.

Joe Graham


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.