Subject: knock sensors common on rotary
From: ACRE
Date: 7/14/2003, 9:01 PM


Has anyone verified that these will work on a rotary?
Chuck


Good question. I called MSD. I spoke to the PR department's Todd
Wright
and they
are going to send me one for testing. They did not freq when I said
"aircraft".

On the other hand you can build your own.
This schematic and photo will work. I tested it by tapping the rotor
housing
with a hammer and listening to the ear phone.
Just a matter of finding the right audio filter band pass and
rectifier
to light some LED's. The noise band is generated by the rotor housing
vibrating
at it's natural frequency.

I notice the three rotor has three knock sensors. Most late rotor
housings
have knock sensor mountings just above the spark plugs.

Paul Lamar


All the rx7 twin turbocharged FDs (93+) have a knock sensor stock.
Circuitry retards the timing automatically according to the manual.
Safety feature....
I have heard that the psru gearbox noise might confuse the knock
sensor-it was not tuned for that noise. But the gearbox on the car, auto
or manual might make the same kinds of sounds.....
[Marc Wiese]

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.