snips..........
At this time the EZ's and the like have no pitch change under power, one of the really bad characteristics of the
'viggen,
which
I believed lead to more than one crash.
Canards are very pitch sensetive to begin with. If moving the C/L of the engine up to use a bigger prop or get more
ground
clearance was a no brainer they'd all be doing it anyway.
...Chrissi
You can't extend the gear and you can't raise the thrust line so Burt
has designed you into a box.
Well you will just have to bear the canard cross then.
Paul Lamar
Paul, Think of the profile differences between the 13B and the Lycoming. The 13B and Tracy's redrive is about the same
overall
length but you don't have the bulk of the Lyc to deal with. Just a nice small diameter redrive and an extension can
increase
the
length by 4, 6, or 8 inches. I'm putting my effort into the arrangement of components so I can take advantage of that
small
profile when I get ready to make a new cowl. That's where some real improvements can be done aerodynamically to improve
in
feed
airflow to the prop. MHO.
Rick
Rick Girard
Well as Chrissi pointed out if you move the prop aft you risk prop strikes.
If you use a 2.17:1 PSRU and go down on the prop dia. to run it at 3600
the engine will run at 7800 RPM. More HP. Doable I guess. What diameter do you need
to run the tips at .8 mach and 3600 RPM? You will sacrifice takeoff
performances which is already not too good on canards.
I still like Vance's Idea. Profile will not be that bad as the top of
the cowl/ canopy can go straight back.
Paul Lamar
Paul, A caveat here as I have no time in type with a canard, but my high time friends tell me that more than one high speed
taxi
has turned into an inadvertent first flight when the throttle was closed and all that down force on the canard from the
already
high thrust line was removed.
Rick
I have not heard that before and find it a little hard to believe. I thought originally Rutan put the down-thrust in there to
improve prop clearance. But since I've read that it was put in to actually help rotation, and since the plane flies with a small
angle of attack, the engine is horizontal when the plane is in "level" flight. If the down thrust helps with rotation, then
removing power should not have the effect described. Also, the thrust line is elevated above the cg at the rear, but probably
passes through the cg at the cg point. Because I was using the stock intake manifold on top of the engine, I took out the 2
degrees of downthrust and lowerd the thrust line about 2 or 3 inches at the firewall. You can see my modified thrustline in this
drawing Paul sent out. It is the horizontal line from the firewall to the front exhaust port. I believe my thrustline still
passes through the cg, and I have no pitch changes with power setting changes. However when I do build a new engine mount it
will have the Rutan thrustline since I no longer have the stock intake manifold.
Perry Mick
Custom Composite Props
mick@bridgingworlds.com
http://www.ductedfan.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.