snip...
If you are going to build a mount for it, you might as well include
torque measurement in the mount. After Bill's experience with current
draw in induction motors, it seems unlikely that you can make any valid
assumptions about required power bu using the current draw of the motor.
Charlie England
Good idea Charlie. I'll see what I can come up with.
BTW Charlie what email program are you using? Why does it add so many quote
indicators? What line length does it wrap at?
Paul Lamar
Great idea Charlie. Here is a preliminary design. The glass plate represents
a piece of 3/4 thick plywood. I made it glass in the rendering in the
hopes that you could see the ball bearing I added to the motor
shaft. The ball bearing will take the belt side load and allow
the motor housing to rotate slightly. Torque arm and load cell not shown
yet. The weight of the motor will be supported by the needle
thrust bearing at the bottom. Big advantage here is this is
the net HP out of the motor. No need to know motor efficiency.
Paul Lamar
Paul,
I just gotta send you and Charlie a note saying that is a really clever idea. Wish I had thought of it.
Ken Powell
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.