Anybody on here have any knowledge of this?
Paul Lamar
Dick Gregory wrote:
Paul, are you interested in CAN for building connectible devices or for monitoring existing devices. From the
previous responses you got, the boards described are mostly for monitoring or controlling via a PC. For low cost
devices, several microcontroller manufacturers are integrating CAN into their chips, such as the Texas Instruments
examples also included in the responses.
I have been toying with the idea of using PIC controllers from Microchip to interconnect my sensors with cockpit
displays for engine monitoring and flight displays. I have looked at both CAN and I2C interfaces which are both
supported on the PIC18F452 which is a 40 pin chip that costs less than $10. It can also input digital and analog
signals, making it suitable for quite a few applications in an aircraft. It is designed to operate in harsh
environments and can be purchased in mil-spec models.
Both CAN and I2C interfaces are performed on the chip with minimal external circuitry. Programming requires a
knowledge of the network architecture and is not trivial. I might be capable of being coaxed to help out with the
programming as a contribution to the advancement of the group. I have the PC based development software and an
interface device to download programs to the chip. I have been programming computers for 35 years in a variety of
languages.
I am not advocating the PIC chips as better than those from TI, National, Motorola, Intel, Zilog, etc. It's just that
they are the ones I have played with on my own workbench. By the way, the PIC18F452 is a big brother of the chip used
on the Basic Stamp if you are familiar with that.
Dick Gregory
I am not sure what are interest are at the moment. I'll get back to you tomorrow
with more info after I fool around with the RX8 system a bit.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.