Paul, this is true, but with some of the vinylester and cyanate ester
composites we post cure in an oven to as high as 450°F These will show
negligible change at 300° and using carbon as a fiber won't lose strenght at
that temp either.
Bill Jepson
Well call me back in ten years :)
Paul Lamar
Krasinski wrote:
Paul,
It may be sooner than that. Look at
http://www.cotronics.com/vo/cotr/ea_ultratemp.htm . Three types of epoxy are
listed there with 600K and 700K operational limit. I checked one of them. It
is an epoxy with a ceramic filler. It will not cure at room temperature, it
requires oven curing. After curing it looks like a black brick and it seems
to be hight temp resistant. But I did not make any measurements of strength.
Cotronics might have all that info.
Jerzy
Yes but how will we know for sure until ten years go by?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.