Hi, Paul.....I am at the stage where I need to install my oil pan. I was waiting for a while until I found out if Perry or
someone else was going to make the oil pans with the fins for cooling and offer them for sale.  I also was interested in an
aluminum pan  from Jerry Hey, but I understand he is in the middle of a move, and not likely to put off his move just to build
an oil pan for me. Then I saw the picture you just posted of the RX8 oil pan....from what I can see, it appears to be low
profile. That would also work, but might be heavier than an aluminum pan. Suggestions, please?  Thanks in advance for your
reply.  Paul Conner

Ed Klepeis can make you a pan to your specs.

Dear Paul
  My new email address is techwelding@comcast.net thanks.
Regards   Ed 270 898 8286

Paul Lamar

I just sent the oil pan parts to Colorado today to get welded. So it
will be a few weeks before I get it back and get it installed and tested.

--
Perry Mick
Custom Composite Props
mick@bridgingworlds.com
http://www.ductedfan.com

Also Bill Mensing at Sheet Craft can make a pan.
Probably at the lowest cost yet very good work.

Bill Mensing
Sheetcraft
447 South Ojai
Santa Paula CA 93060
805 525 3942

bill.sheetcraft@verizon.net

Make a sketch and send it to him.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.