I do have some hose in there and yes it does expand and get hard.
A lot of liquid cooled airplanes use aluminum tube plumbing anyway and
yes I know nothing is infinitely ridged.
... much to Gail's loss. ;-) BTW, it's "rigid".
BTW There is one mode of operation I have not tried yet.
When the expansion tank and pressure cap is located between the rad and the inlet
to the pump, and the pressure on the inlet side of the pump is
below atmospheric pressure, fluid will be drawn in from the overflow
tank through the pressure cap one way valve and the pressure on the outlet
side of the pump will increase until the negative pressure is
normalized to atmospheric pressure.
But in your pre-pressurized system, the pump inlet will never go below 1 atm,
correct?
Yes.
The pressure differential across the pump will remain the same however.
That can be simulated by putting about 15 psi pre pressure in the
test cooling system.
I want to point out that no amount of increased fluid volume on the inlet
side of the pump is going to make a hill of beans difference
in the closed loop system situation.
You must also realize that any open loop system
sucking from an open container at roughly the same inlet pump level will have
atmospheric pressure on the inlet side of the pump. The same thing
cannot be said about a closed loop sealed cooling system such as we
are dealing with here.
BTW A block of water one foot cube exerts a force on the table it is
sitting on of 65 pounds.
That is 144 square inches so that is 65
pounds divided by 144 or .45 psi. That means a 12" column of water one inch
square weighs .45 psi. A stand pipe on the inlet side IF OPEN AT THE TOP
will exert .45 psi for every foot in length. It matter not how large in diameter
the stand pipe is. It could be the size of the lake behind Grand Coulee
damn and it would still be .45 psi per foot.
This is also the principle of the water manometer which we should all
be very familiar with by now.
So far, so good.
Unfortunately it is not open on the top so the air pressure above the column tends
to hold the water from running out. Just like a pipette or soda straw works when
you dip it into a glass of water sealing the end with your finger.
You just made a mistake. When you put your finger on the soda straw, it isn't the
air trapped by your finger that is keeping the water in the straw. The air *outside*
the straw is pushing on the water at the other end of the straw, and capillary action
keeps the water from dribbling out. If there were no air at all trapped by your
finger, the water will still stay in the soda straw.
Yes you are right.
It's not immediately clear what point you were attempting to make about the test
rig. The test rig is a closed system.
And a sealed system. But people are not getting the message.
This is a whole order of magnitude less pressure than we are dealing with in these
pump system so a stand pipe is a waste of time.
Mostly true. If the test ring were completely evacutated and filled with water that
had no entrained air, and pressurized with that same water, then the pressures
withing the system would be zero sum: increased pressure at the pump outlet is
exactly offset by reduced pressure at the pump inlet. This is because water is
essentially incompressible and the test rig is rigid. (There would be some small
compression of the water and expansion of the test rig, but I believe our instruments
would be incapable of measuring it.) By having a stand pipe, and more importantly an
air cushion, we lose that "zero sum" aspect. This is because the air cushion will
compress (or expand), which throws off the pressure readings (w.r.t. "zero sum").
Russell Kent
Correct! "withing" ?????? :) People in glass houses...........:)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.