Also Bill Mensing at Sheet Craft can make a pan.
Probably at the lowest cost yet very good work.

Bill Mensing
Sheetcraft
447 South Ojai
Santa Paula CA 93060
805 525 3942

bill.sheetcraft@verizon.net

Make a sketch and send it to him.

Paul Lamar

Paul,
This is another thing I will make for the local market now I have a better
understanding of pattern making. I looked at this (oil pan) initially as a
possible engine mounting place. I now understand the limits on the thinness
of the fins for moulding purposes - should be a hell of a lot easier than a
bellhousing.
George (down under)

Yes it would be but it would also be much much heavier than one made
from .049" thick aluminum sheet.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.