George, none of this is meant to disparage your efforts, and I wish you
luck. I  get a bit peeved at all the feather merchants who knock Tracy

all

the time. We'll get the real poop after the first couple are cast. If

they

do cast well, Just cut a few open and take a look at the metal, and test

the

hell out of it before you fly with one. I have to call em like I see em.

Monty

Monty,
No insult taken on my part mate, I support Tracy's efforts as well !! I also
understand what Paul is saying as well.

Just to reconfirm the foundry is run (hands on ) by an ex-racing driver who
has done many bellhousings over the years, he knows his stuff.

He uses the very best material and can heat treat on site.

My first job was in a foundry and I know a little.

Both Paul and (Butch an engineer) have had a fair say in the design
parameters i.e. thickness etc.

Paul has agreed to test the hell out of it, for all our benefit.

I also applaud your loyalty to Tracy and his skills and efforts.
I personally think we will all benefit from a combined effort - I know I'm
learning every day.

I guess I am lucky, I'm retired and have the time to put towards the effort.

I have been personally criticised by some, for following Paul's lead ( I
believe the term was hanging on to his apron strings), however I think for
myself and stated so strongly, however I  am very happy for the advice given
from both Paul and Butch, and think that's what it (experimental) is all
about, being open-minded and working together for a common cause.

Enough from me !!

George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.