Stuck way away on the North Forty in the ignored pusher lot was Charlie
Airesman's Varieze. We need to start the Home built Aircraft
Associations and dump the now ex EAA and OSH. No war birds, no car dealer
ships, no air shows, no Airbuses and no certified airplanes commercial
displays. Interesting experimental and rotary engine powered
aircraft where scattered all over the EAA facility. It cost me
alone $230 to camp and get in for one week. Hot dogs were $3.75 with
kick backs to the EAA. I spent a lot of time working on and presenting
no less than two non commercial forums with no dispensations or benefits
from the EAA. I digress.
Charlie did away with
his long carbon fiber shaft and prop support bearing structure
and simply made a large diameter carbon fiber prop extension and bolted
it to his flywheel. Charlie says it is almost as fast as
his old setup. Namely about 230 MPH with a 2.4 L direct drive Soob.
He is also still using the thrust augmentors with a rather small rad
and NACA duct so it must be working. Klause told me it does
tend to over heat at top speed so that is consistent with what
we know about thrust augmentors and NACA ducts.
Charlie makes his own props. As I recall he fabricated a three
prong unidirectional carbon spar and then molded micro balloons on for
leading
and trailing edges. I need to get more info on this prop making
technique from him.
He also extended the bottom part of the fuselage all the way back to the
prop
to serve as a very light weight bed type motor mount. To service the rad
you need to remove the engine.
This is Charlie in the picture.
Paul Lamar
"Steven E. Odle" wrote:
H.A.A. Homebuilt aircraft assc.---- sounds good to me!
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.