Bob White wrote:

Hi Paul,

I was off the list for about 10 days just before you went to Oshkosh so
I missed some stuff.  What is the status of the water pump castings?

Thanks,
Bob White

- - - - - - -
http://www.bobwhite-abq.com
N93BD - Rotary Powered BD-4

Next on the agenda. Karl kindly machined a bunch of pipe barbs and delivered
them to me at OSH so those are done. I need to make a drill jig for
drilling the cartridge mounting holes and hope to have that done this week.
Hopefully I can ship the pumps before I go to my my sons wedding 
for a few days in Toronto on the 15th.

BTW Karl, send me your address by private email so I can send you a
check.

Vance has taken over the pump testing and will build a pump dyno so we
can determine the HP and flow at higher than 4300 RPM. I loaned him
the flow meter and pressure gages along with a stock pump and the
closed loop system that I built.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.