Subject: 1000 HP Air boat motor
From: ACRE
Date: 8/6/2003, 10:45 PM


-clifton j dugan wrote:

I am new to this forum and know nothing about rotary engines other than
they
don't have as many hand grenade problems.   My desire is to have a high
horsepower power plant for an airboat which has no weight requirements
and
has lots of room for coolers and radiators of large size.    I need to
have
a power plant that will put out 750 horsepower with a high reliability
factor and don't care about weight nor space.  Gearbox reduction for
propeller needs to be reliable and handle the horsepower  but can be any
size.  Airboat people are already using good props that can handle the
horsepower but I haven't seen any rotary engines although I know there
must
be some.  It seems like a three rotor with turbo might fit this
requirement.
Several of my friends are using big block chev engines putting out 700
to
900 horsepower but they hand grenade them often.

Any idea about where I might get more info on this subject?
Boy, you guys sure bash this scoop problem pretty well.  I know cooling
is a
serious subject with airplanes.

Clif-

Contact Racing Beat Clif. They have just what you are looking for. 1000
HP.
350 pounds. You will need an old Bell 47 Helicopter gear box for the
prop.

http://www.racingbeat.com/

Paul Lamar


BTW Clif I think you would be better off with two turbo 13B motors.
More prop area for better low speed thrust. Up to 800 HP each on alcohol
and nitrous oxide. Twins airplanes always climb better than singles for
this reason.

Paul Lamar

clifton j dugan wrote:

Twin anything just seems like double trouble to me.   I need something
fairly straight forward that runs on pump gas as airboats go in some unusual
places and gas is hard enough to come by sometimes.  I know nitrous and
alcohol are good but hard to re supply in a swamp.  I would like to have
enough motor so that the 750 horsepower is conservative instead of on the
edge.

Reliability is still very important in this.  Most airboat people use large
cog belts to gear down the motor to prop speed and are getting good service
at 800 horsepower.  I know that airplane people need something lighter and
more reliable but this is working good on the boats.  The belts are lasting
much longer than the motors.  I am looking for something that has the
horsepower with reliability and fairly low maintenance.   I know that this
sounds like a dream but the rotary seems like the best possible answer to
me.   These standard car motors that are revamped for high horsepower just
have too many parts to break.  Even using the latest high tech racing parts
they just don't last very good, as it looks like the airplane people already
know.
Clif

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.