Paul, You mentioned a radiator supplier for custom sizes
 > other than Griffin. Said there was "no epoxy used". Didn't
 > manage to save that one. Who are they? I think Lynn
 > Hanover used them as well. Bill Jepson

I use Griffin. Cheap, and no problems.

Lynn E. Hanover

Lynn, I know they are welded or brazed but don't they also use epoxy
around the base of the tubes? I might add it was Griffin that supplied
the oil cooler that split in at least three instances resulting in two
in-flight fires and one seized engine resulting in a fatal crash.
I suspected it was made in China. Use only oil coolers that have been
tested at well over 100 psi. Or just use the stock Mazda oil cooler.

Paul Lamar

Being familiar with those cases, I will just say this: if you don't
design the installation properly, and don't specify what you need to the
maker of a custom cooler, you can't blame the maker.  Griffin makes
their own oil coolers.

I have a custom Griffin oil cooler that I'm impressed with (the stock
Mazda not big enough for a 20B).  I specified 125 psi operating
pressure; it was tested to 150 psi.  It hasn't flown yet, but I have
reason to be optimistic.

Al

That is different than the Griffin oil cooler I saw that failed. The one I saw came in
a Chinese card board box. I know Chinese card board when I see it as I used to sell
clone computers. :)  Yours looks pretty good. For other people installing
a three rotor what did it cost?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.