Mike Collier wrote:
George, keep me on your list for one.. You guys are doing great
work..
Mike C.
Mike,
Will do matey, I'm pumped-up to get it finished.
BTW when do you need it - would you be interested in the prototype after
Paul has tested it?
Just a thought !!?
George (down under)
George,
I'm in no hurry. I still have a lot of work to do to the Long EZ before
I'm ready to Mount the Engine (engine is still in the crate), maybe 3-4
months when I get back to work on it.. Just moved and changed jobs so I
still have to unpack and set up the shop... Right now, I'm collecting parts
and dreaming of when I can get back on task... Your new bell housing will
be a sweat touch... question: I thought you would test the prototype to
failure?? (i.e. bolt it on to a fixture and hang weights on an arm until if
cracks or deforms, so we will have an idea of where it will fail or can that
be predicted based on your modeling).
Mike C.
Long EZ, Long nose, 13 BREW
No point in that. We know what kind of gyro induced bending loads a prop applies
to the bell housing so we will test it for stiffness when subjected to those
loads. Namely 600 foot pounds. The failure stress level is way beyond what is
required for adequate stiffness. We will probably use the same equipment Jerry
Hey used to test the motor plate for stiffness. Hopefully Jerry still has most
of the test rig parts. Jerry? The test applies twice the expected torque.
Stiffness in the bell housing is required to keep Tracy's input shaft in
reasonable alignment when the aircraft is subjected to turbulent or violent
maneuvers such as a stall or spin.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.