George Lendich wrote:

Paul,
I've arranged to have the centre hole machined as well, I would

like

all

the

numbers recorded for a complete CNC process. Do you have some more

detailed

drawings on the Tracy's PSRU hole pattern - it would be nice (and

cheaper)

to have it all done at once.

It will be done next week.

George (down under)

Just what I sent you George. Tracy can you help out?

Paul Lamar

Paul,
 I just went through the records of 2 computers and don't have anything

more

on the PSRU pattern, other than it's diameter and hole sizes - I suppose
that will have to do.

Tell me do the 1/4" bolts screw into the bellhousing ( do I need

threaded

holes) or is there nuts etc. inside the housing to retain the PSRU.
George (down under)

I'm still not sure what data you are in need of here George.  I've sent the
adapter plate drawing a couple of times (same one Paul published here many
times).  If it is the hole pattern for the gear housing you need, it is a 12
hole circle (1/4" holes) with a 5.875" diameter.  I use nuts on the back
side as Paul said. You may have to use nut plates since the bellhousing does
not give good access to the back side.

Tracy

I am planing on cutting a bunch of 2.5 inch holes were possible to cut the weight.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.