marc wrote:
Interesting data Al thanks. The RX8 200 HP has one rectangular oil
cooler about 8 or 10 inches square mounted just ahead of the left front
tire and just behind a large scoop. The 250 HP version has two. One on
each side.
There are no stone gards in front of them so new ones will be a popluar
item in the parts department for a few years not to mention ruined
engines that have been run with no oil pressure as a result of FOD :)
First think I am going to do is make a screen to fit in the scoop hole.
Hint hint... Jim.<<<<
You got that right! I have a stack of FD oil coolers and they are beat
to sh,,,. No stone guards. I glued in fiberglass screening in front of
mine after seeing a few. Hope it didn't lower the air pressure! Also
sounds like the rx8 copied the rx7 FD cooler scheme almost identically.
The r2 version has 2 cheek coolers, the standard version just one. They
are about the same size as the rx8 ones! The auto tranny FD just uses
the same oil cooler for a tranny cooler by exchanging the adapters. That
says a lot about the pressure taking capability of those stock Mazda
coolers-what does a tranny run the pressure of the fluid at? I will use
them in any combination I need to control the oil temps-they also give a
lot of flexibility.
Marc Wiese
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.