George Lendich wrote:

I'm still not sure what data you are in need of here George.  I've sent

the

adapter plate drawing a couple of times (same one Paul published here

many

times).  If it is the hole pattern for the gear housing you need, it is

a 12

hole circle (1/4" holes) with a 5.875" diameter.  I use nuts on the back
side as Paul said. You may have to use nut plates since the bellhousing

does

not give good access to the back side.

Tracy

I am planing on cutting a bunch of 2.5 inch holes were possible to cut the

weight.

Paul Lamar

Tracy,
Thanks for the advice mate, I had considered the possibility of a nut
plate - it does seem logical.

The PSRU mounting holes had me a little confused as I saw a couple of
different drawings, showing slightly different positions and didn't know for
sure if the PSRU had to be placed exactly ( if there was an up down, left or
right).

I didn't want to stuff-up at this late stage!!

One drawing showed a mounting hole at 12, 3, 6, 9 O'clock etc and another
showed  it at 'each side' of 12 3,6,9 O'clock etc.

Since it is your drawings, I will assume that it is equally spaced at
5.875" - each side of 12, 3, 6, 9 O'clock etc.

Thanks again for the confirmation.

George (down under)

Equally spaced 5.875 bolt circle. Exact orientation not critical.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.