Fred Osborn wrote:
Fred Osborn wrote:
Paul, I would like to use a Shertz beam type mount for my one rotor
0.65B engine. Instead of the 4130 rectangular tube beam that Bill used I
would like use an aluminum angle beam with a vertical leg of perhaps 4".
This leg would also form the rear wall of the oil pan. The horizontal
leg would be wide enough to take the rapid pitch gyro loads and for the
Barry isolators, at least 2". Would you be willing to recommend a
thickness for such an angle or is this just another of my wild ideas ?
Fred O.
That sounds like it ought to work. About .25" thick should work. How long is it?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.