Subject: Fuel Schematic (Draft) for the Glastar
From: ACRE
Date: 8/13/2003, 10:49 PM


Del Johnson wrote:

Attached is a  jpg file of the fuel system that I am designing for the
Glastar.  The Glastar has two small header tanks.   I'm
not using the intake manifold that is now available from Paul and am
therefore using two fuel rails similar to Tracy's
installation.  I'm hoping to use two 60 microns filters from Summit
Racing (SUM-G1518) and locate them at the inlet to the fuel
rail. Each filter will be supplied fuel via separate pumps but the fuel
rails will be cross connected so that fuel will be
supplied to both rails if only one pump is turned on.

 One question that I have is whether or not one pressure relief value
can be used to handle the return fuel flow or should I
locate a pressure relief valve on each rail?  Note that the rails are
cross connected.  Also I would like to entertain any
oither comments about the design.

I am aware of the potential fuel heating problem of returning the fuel
to the header tanks.  If need be I will fabricate a
cooling jacket around the intake scoop ( 3" diameter aluminum tube) and
let the fuel circulate through the jacket before
returning to the header tanks.  Stoddard Hamilton retrofited the kit
with header tanks to solve a fuel starvation problem were
there was a significant amount of fuel remaining in the main tanks.  It
would defeat the header tanks to return the fuel to the
wings.

-John Gibbons wrote:

Del,
    I have flown three Glastars, 2 with Soob and FI. The homebuilt Soob had
a similar set up with one header tank behind the seats, probably about half
a gallon. The other was NSI with a one gallon header tank on the firewall.
Never has fuel heating been an issue with either system. With the NSI at
about 65 degrees OAT and low slow flying searching for some missing divers,
I hopped out and pulled the cowlings as quick as I could. Most parts of the
engine and its components were too warm to keep your hand on and yet the
header tank an inch away was cool to the touch.
John- 

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.