Subject: Fuel Schematic (Draft) for the Glastar
From: ACRE
Date: 8/13/2003, 9:04 PM

Del Johnson wrote:

Attached is a  jpg file of the fuel system that I am designing for the Glastar.  The Glastar has two small header tanks.   I'm
not using the intake manifold that is now available from Paul and am therefore using two fuel rails similar to Tracy's
installation.  I'm hoping to use two 60 microns filters from Summit Racing (SUM-G1518) and locate them at the inlet to the fuel
rail. Each filter will be supplied fuel via separate pumps but the fuel rails will be cross connected so that fuel will be
supplied to both rails if only one pump is turned on.

 One question that I have is whether or not one pressure relief value can be used to handle the return fuel flow or should I
locate a pressure relief valve on each rail?  Note that the rails are cross connected.  Also I would like to entertain any
oither comments about the design.

I am aware of the potential fuel heating problem of returning the fuel to the header tanks.  If need be I will fabricate a
cooling jacket around the intake scoop ( 3" diameter aluminum tube) and let the fuel circulate through the jacket before
returning to the header tanks.  Stoddard Hamilton retrofited the kit with header tanks to solve a fuel starvation problem were
there was a significant amount of fuel remaining in the main tanks.  It would defeat the header tanks to return the fuel to the
wings.

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.