Subject: Fuel Schematic (Draft) for the Glastar
From: ACRE
Date: 8/14/2003, 10:40 AM


 One question that I have is whether or not one pressure relief value
can be used to handle the return fuel flow or should I
locate a pressure relief valve on each rail?  Note that the rails are
cross connected.  Also I would like to entertain any
oither comments about the design.

I am aware of the potential fuel heating problem of returning the fuel
to the header tanks.  If need be I will fabricate a
cooling jacket around the intake scoop ( 3" diameter aluminum tube) and
let the fuel circulate through the jacket before
returning to the header tanks.  Stoddard Hamilton retrofited the kit
with header tanks to solve a fuel starvation problem were
there was a significant amount of fuel remaining in the main tanks.  It
would defeat the header tanks to return the fuel to the
wings.


Hi Del,

    Similar arrangement that I have in my RV-6A except my small (approx 1
quart) header tank is on the forward side of the firewall.  I have cooling
air directed on the pumps and header tank as well as a low pressure boost
pump on the tank side.  I found that using Autogas on a very hot day a
tendency for the fuel to perculate.  Turning on the boost pump stops it.  My
boost pump produces approx 6 psi fuel pressure.  Perhaps the head pressure
from wing tanks and having the header tanks out from under the cowl will
preclude you from having this problem.

Regarding pressure regulator, with both fuel rails tied together, one
pressure regulator should handle both just fine.

One question, on your schematic you show a filter after the EFI fuel pump
with a relief valve.  What is the function of the relief valve?

Ed Anderson
RV-6A N494BW Rotary Powered


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.