<snip>
I am aware of the potential fuel heating problem of returning the
fuel
to the header tanks. If need be I will fabricate a
cooling jacket around the intake scoop ( 3" diameter aluminum tube)
and
let the fuel circulate through the jacket before
returning to the header tanks. Stoddard Hamilton retrofited the kit
with header tanks to solve a fuel starvation problem were
there was a significant amount of fuel remaining in the main tanks.
It
would defeat the header tanks to return the fuel to the
wings.
-John Gibbons wrote:
Del,
I have flown three Glastars, 2 with Soob and FI. The homebuilt Soob
had
a similar set up with one header tank behind the seats, probably about
half
a gallon. The other was NSI with a one gallon header tank on the
firewall.
Never has fuel heating been an issue with either system. With the NSI at
about 65 degrees OAT and low slow flying searching for some missing
divers,
I hopped out and pulled the cowlings as quick as I could. Most parts of
the
engine and its components were too warm to keep your hand on and yet the
header tank an inch away was cool to the touch.
John-
I'm not going to fabricate the fuel cooling jacket until I have to. I will
try flying the plane without it. However, I think if you found that you
needed to cool the fuel circulating it around the air intake scoop would
probably be a reasonable solutions.
Del
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.