Subject: proper material for shaft/ heli design
From: ACRE
Date: 8/18/2003, 5:37 PM


Thank you Royce. I'll go poke around. I always seem to get a bunch
hits on RC model stuff.I need to learn to search better. :) I found
a book in the back of my 'Aircraft Spruce' cat. by Dr. Eric Hollman
and Martin Hollman called "Modern Helicopter Design" I'll be
ordering. It comes with several programs as well. I hope it'll be a
good source of information.



Phil


I have about every book on this subject available.  I recommend
Rotary-Wing Aerodynamics for bang for the buck, it has a lot of simple
equations for performance calculation.  Martin Hollmann's book is
expensive and the programs are very basic.  Of course anything that Ray
Prouty has written is excellent but tend to be more conceptual, but
definitely worth a read to save you time and $ in your rush to
prototype!

Ray Prouty who has worked for all the major Heli companies and was the
chief aerodynamacist for the MD500 series, is an excellent writer, very
clear.

Here is a link to some of his articles that he wrote for "Rotor & Wing":

http://safecopter.arc.nasa.gov/Pages/Columns/RayProuty/ColPrty.html

He is teaching the premier class on "Helicopter Performance, Stability
and Control" in Sept, here is the link:
http://www.kuce.org/aero/hpsc.html

I also would encourage you to consider a single engine design for
efficiency, and your engine weights for a 13B are too optimistic, no
one I know of has an installed weight of only 200 pounds, the bare
block itself is 190.  On the positive side I think your HP estimates
for a turbo 13B are too low, 300 continuous HP from a turbo 13B is easy.

Of course none of these will have the basic mechanical engineering
strength calculations that you are looking for, but a further
refinement of your design as far as gross weight would be good before
you knos how strong it needs to be.  As I recall a safety factor of 3
is standard for helis, with a safety factor of 7 for the rotating parts.

Hans Conser

PS  Martin Hollmann quoted me $120,000 for a complete design of a 4
place helicopter, down to blueprints for every bolt & blade.  That is a
great price if the design is good.


Thanks Hans,

    To show you how far off I am, I've been trying to use a safety
factor of 10 for the rotating parts! :)

    I don't know if you caught the rest of my pipe dream but it (my
dream) is a small two place (heavy lift) coaxial with a fixed pitch tilt
type rotor. The two engines would be, hopefully, to eleminate any need
to auto-rotate.  I'm still respectful enough of chance that I'll mount a
ballistic system above the rotor head.

   I've decided on the ShopMaster 3 in 1 CNC machine to purchase for
this learning process. Worst case, I'll end up with a machine to build
parts for my car. :)

Thank you for your time and thank you for the links!
Phil Williamson

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.