Second pic shows the completed installation.  At the pump outlet at the
top you see the air bleed (AN o-ring plug drilled up the center and out
the side just below the o-ring. Loosen it a turn and the air can
escape), the pressure sender below that, and the low level sender at the
bottom of the overflow bottle.

Al

*****************************************************************************

Hi Al;

I've been following your 20B installation for quite a few years with shear
admiration towards your very, very "High Standards"......You are a very
meticulous individual which stops at nothing to achieve very high quality
results which elevates the standards of our Rotary movement.

My CONGRATULATIONS!!!!.......Your Installation is by far 5 Stars PLUS and
pretty hard, if not impossible to beat. Keep up the great work.

                                                    Butch

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.