Subject: Recycle Fuel of fuel to filter/header tank
From: ACRE
Date: 8/20/2003, 9:38 AM


Keith Moore wrote:

It is time to stop and think about  "recycle" of  fuel from
the
engine
to a
header tank (or fuel filter or some other).

1.  What happens if air gets in the system?
2.  What happens if you run one tank dry, then switch tanks?
Where does
the > > Does this system use a separate header tank vent or is
it
closed?  If the above
problem is a big issue, and getting return lines back to the
original
tank,
would a header tank vent exiting above the main tank vents allow any
trapped air
to escape?  Or could the header tank vent actually pull air
preferentially over
fuel if both were possible?

Scott Gettings

Since I have one of the systems described by Keith and have been running
the
engine with it for 300 hours, I would like to comment.  First, if you
are
going to use such a system (small header tank) with fuel being returned
to
it,  1.  DO NOT vent it to the atmosphere. 2.  Keep it where the
returned
heated fuel can cool off.

 Keith is correct that an air leak (or vent) would preclude the pressure
differential being developed that "sucks" the fuel from the tanks.  The
EFI
pumps created a considerable pressure differential as they "suck" fuel
from
the header tank and pump it into the fuel rails/injectors.  If an air
leak
develops then that pressure differential is compromised and the ability
of
the system to "suck" fuel from the low wing tanks of my RV (probably
would
not effect the high wing tanks).  I recognized that as a possible
problem
mode during its design.  Therefore,  I took three steps to minimize that
risk.

1.  The tank is welded out of a 1/8" thick aluminum rectangular tube
with
plates on both ends and all fittings welded by a certified welder.

2.  The tank was tested to 150 psi for leaks (strongly recommended if
you
are going this route)

3.  There is a boost pump between the header tank and the fuel tanks
which
will force fuel into the header tank (although if you have a leak - in
any
system - forcing more fuel to the leak is probably not the wise thing to
do)

The thing I think of more concern with this type of header system is
keeping
the returning fuel cool enough so no vapor lock occurs.  I have noticed
that
using autogas on a 100F day will cause the fuel pressure to fluctuate
while
running the engine on the ground.  Turning on the boost pump for take
off
(and landing) eliminates that fluctuation and once airborne with high
fuel
flow and cooling air the fluctuation goes away (even with auto gas).

While I am pleased with my system, I do not necessarily recommend it if
there are feasible alternatives such as returning heated and unused fuel
to
a main tank tends to elminiate the fuel heating problem and if your
system
permits this easy enough, then why not do it - if you don't mind the
increased complexity of the pumbing {:>).  I had already built my fuel
system, and did not like adding additional fuel lines and six port
switch in
the cockpit area.  Yet I wanted to keep my ability to switch between
fuel
tanks as well as turn the fuel off.  There are other alternative designs
that will work as well (such as the one Tracy Crook uses).

FWIW

Ed Anderson


Ed,
    You mention RPM surges on the ground during hot weather but would settle
down in flight. I am guessing you are attributing this to hot fuel. How
large and where is your tank ? Have you been able to check the temp of the
fuel, even by holding your hand to the header tank ?
Thanks
         John

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.