George Lendich wrote:
What do you mean "Don't write me off yet!" Who is writing anybody off?
Tongue in Cheek Paul !!
Are you willing to try this idea George?
I certainly looking at it seriously, I just don't know how to get that shaft
shaped. I got to do something and I'm getting suggestions from a number of
sources - non of them perfect. Yours is the best suggestion, but I have to
look at the production feasibility of producing them in numbers -cost
effectively.
One suggestion I'm considering is a double (paired) roller taper bearing at
the front (for thrust and side loads) with a plain bearing at the rear. This
system takes into account the difference in the expansion rates of the steel
shaft and the aluminium housing. The problem here is preload setting on the
taper roller bearings and how they can be simply set (adjusted).
George (down under)
That's why you should use cheap needle roller bearings like Ross did.
The hollow prop shaft and bearings never gave any trouble. The only trouble
with the Ross when it was made accurately was with the lack of a helical
gear thrust bearing. It was missing :)
Furthermore you cannot beat a needle bearing for load to weight ratio.
They weigh nothing and accept huge loads as long as you don't run them too
fast. They also cut the weight of the housing as they don't take up
a lot of room.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.