Hello Chris,
That was me asking about the V-tail wollowing (boogie)
phenomenon.
Thanks for clearing that up!
You didn't say if you need a bell housing !!?
George (down under)
I'm definitely interested in the bell housing. Especially if
it's a
strength/weight improvement over Tracy's current design, with all
greatly deserved respect.
Chris,
Good -oh!
Paul will be testing the prototype for strength - it's currently at
the
machinist awaiting in line for work to be done.
I am keen to see my bellhousing in your new machine.
George (down under)
George,
We're a bit tight on weight right now. Does the housing weigh
more than the RD-1B's stock mount?
It does Chris. ( I don't think George knows the weight of Tracy's set
up).
I plan on cutting a lot of holes in low stress areas so we shall see
when I get it.
Also it forms part of the motor mount so that must be taken into
consideration.
Paul Lamar
I'll go weigh my setup now. If it'll simplify the motor-mount, then it
may save weight in other areas.
Chris Cosman
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.