Subject: Chain drive Hollow shaft PSRU
From: ACRE
Date: 8/22/2003, 3:24 PM

George Lendich wrote:


That's why you should use cheap needle roller bearings like Ross did.
The hollow prop shaft and bearings never gave any trouble. The only
trouble
with the Ross when it was made accurately was with the lack of a helical
gear thrust bearing. It was missing :)

Furthermore you cannot beat a needle bearing for load to weight ratio.
They weigh nothing and accept huge loads as long as you don't run them too
fast. They also cut the weight of the housing as they don't take up
a lot of room.

Paul Lamar


Paul,
I'm hearing you !
Also use a couple of needle thrust bearings for the planet housing !?
George (down under)

Front and back in this 2.85:1 design as the planet housing rotates
so all prop thrust is applied to the planet housing. Tractor and pusher.

BTW I also use them to handle the helical gear thrust by putting another
couple inside the prop shaft. Since the prop shaft rotates in the same
direction as the input shaft in a 2.85 unit the RPM difference is
only about 3000 RPM extending the life of the needle thrust bearings.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.