Harrison,
Here are some more pictures and illustrations for the light weight
hollow prop shaft that nobody has tried yet. The idea here is to
use the pinion shafts to connect the prop shaft directly to the
rotating planet carrier. This minimize the load path and eliminates
the cost and weight of splines. The same idea is used on the prop
end. The prop drive lugs are welded directly to the flared hollow prop
shaft. These are threaded internally for the prop clamping bolts.
No conventional prop shaft steel flange is used. This in theory cuts
the weight greatly. The prop flange (spacer, back up washer) shown
can be light weight aluminum as there is no load on it.
Since you have an NC mill and you are willing to build your own PSRU
you are the ideal person to try this idea.
I'll send some pictures of the planet gear set shortly so you can get
a feel for how small and light weight it really is.
Paul,
I've been thinking about the easiest way to manufacture this PSRU shaft and
came up with the idea, which may be the easiest way, that is to Laser cut it
out of flat Chrome Molly (or similar material) roll it, then weld it up -
then x-ray it.
The notches for the hollow internal threaded shafts could be done at the
time of cut-out.
I think you suggested 3/16" steel previously, naturally the thinner the
material the easier it would be to roll. perhaps it could be thinner - may
be an 1/8".
Any comments ?
George (down under)
1/8 inch would probably work. The FEA on the shaft did not show high
stress levels.
I guess that will work but I was thinking of hogging it out of billet
or thick wall 4130 tubing on a big NC lathe. It must be hardened and ground
as the needle bearings run directly on the prop shaft.
Ignore the deflected pinion shafts on the input end. That was a mis-
understanding on the part Dan Ruggirello's of how it worked when he did
the first FEA's.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.