Subject: Low profile water pumps ready to ship.
From: ACRE
Date: 8/22/2003, 10:38 PM

CozyGirrrl@aol.com wrote:

In a message dated 8/22/2003 3:21:37 PM Central Daylight Time, rotaryeng@earthlink.net writes:

Paul, money order is on its way!
...Chrissi

Thanks Chrissi.

Paul Lamar


big question, is it going to be possible to use this and the alternator and
clear the crank angle sensor?
We have Tracy's ignition and are clueless how to mod that to the flywheel.
...Chrissi

You have a 93 and later engine so the crank angle sensor should clear
the belts. You will have to use an earlier V belt pulley on the e-shaft.
You might have to weld the interrupter ring to that.
Got any pictures of the front of your 93 engine?

BTW folks digital cameras are getting real cheap. I highly recommend
getting one for internet communications.


Paul Lamar


Well thats good news then. Our 3rd gen engine is somewhat a hybrid in that it uses an early oil pan (small and wedge shaped) and
a 2nd gen front cover for the mounting points and mechanical oil injection pump.
...Chrissi

OK I see what is going on. You have the crank angle sensor and an early
12A front cover.  The pump and alternator should 
work no problem. Watch out for the belt rubbing on the crank angle sensor and the oil
outlet fitting.

I would space the e-shaft pulley out about 1/2 inch. That should clear both.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.