What you get is one pump housing and six metric bolts, nuts & washers with
the in and out hose barbs. You need to have these welded on if
you are going to use hose or weld on AN or Wiggins coupling fittings.
Your choice. The pump on the lower left is the tested prototype.
The pump requires and early 7 bolt Mazda water pump cartridge.
Something most of you should have.
The pump pumps more water per minute than the stock
pump and has the advantage of being mounted lower. This means
it will still circulate water in the cooling system if the level drops down
as much as 10 inches. This should give more time to find an airport
in the event of a cooling system leak. The pump can be mounted
on the plug side of the engine just like an alternator.
When these are gone I won't be machining any more until if and when I get
an NC mill. Unless of course someone steps up to the plate with an
NC mill and machines them for us. I'll be glad to supply more raw castings.
As it is now it is too time consuming for me to machine these pumps with
the machine tools I now have. Too many set ups. Too much time.
If you have an airplane with a low cowl it would probably be easier
to use this pump than cutting down the stock pump. However if you
choose to cut down the stock pump I can show you how I cut down
mine.
If you want one send a check for $250 to:
Paul Lamar
830 East Santa Maria St.
Suite 303
Santa Paula, CA
90077
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.