> > As a side note, the EFI fuel systems of many (most?) new automobiles
(including the new RX-8) DO NOT return fuel to the tank - they don't
even
have a header tank for returned fuel. . I think they basically handle
the
vapor problem similar to my solution which is increasing the pump
pressure
to push the vapor back into solution. Paul (our host) has more
information
on that I believe. Paul?
Ed Anderson
The no return systems are predicated on the high pressure pump being IN
the tank.
It might work if the pump is very very close to the tank.
Paul Lamar
Ed Anderson wrote:
Ok, thanks for clarifying that, Paul. Apparently the high pressure of the
pump is used to control any vapor forming problems, but needs to pressurize
the entire fuel line to be effective. Lets see perhaps if I replaced my 6
psi boost pump (near the tank) with an EFI high pressure pump......
Ed Anderson
Use a large connection to the pump from the tank so the inlet
of the pump can be flooded with cool fuel. Say one or two inches in diameter.
I don't know if it is possible to install a high pressure pump in an RV fuel
tank like is common practice in cars now a days.
Thinking out loud:
Another approach for you to try is install a Holly carb float bowl needle valve
in your header tank and vent it. When the header tank is full the float valve will
close preventing the low pressure pump from pumping any more fuel... just
like a carb works. I used this idea a few years ago in a fuel consumption
measuring rig for a van.
That will separate the vapor from the header tank. If the vent is in front
of the windshield you will know if and when the float valve sticks open
and fuel is being pumped overboard.
Better yet run the vent line back to one of the main tanks. In case
of valve failure the low pressure pump will just keep circulating the fuel.
Also install the high pressure pump inside the header tank.
The down side to all this is the additional current draw of the low
pressure pump while with your current system the suction created by the high
pressure pump draws fuel from the main tanks (if I understand it correctly).
In Perry's similar system he is using gravity to fill the header tank.
Here too is a picture of a Ford in-the-tank high pressure pump
sent by Ken Powell.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.