I don't know if you caught the rest of my pipe dream but it (my
dream) is a small two place (heavy lift) coaxial with a fixed pitch tilt
type rotor. The two engines would be, hopefully, to eleminate any need
to auto-rotate. I'm still respectful enough of chance that I'll mount a
ballistic system above the rotor head.
I've decided on the ShopMaster 3 in 1 CNC machine to purchase for
this learning process. Worst case, I'll end up with a machine to build
parts for my car. :)
Thank you for your time and thank you for the links!
Phil Williamson
Thomas y Reina Jakits wrote:
Hello Phil Williamson,
I read some of the threads about your helicopter project:
Donīt want to discourage you, but:
a) This typ has been done before by "Eagles Perch Inc." - canīt find them on
the net anymore but you might find some images of their machine. Single
seat - twin engine - fixed pitch rotors - lift control via engine rpm
variation - safety via parachute thhat fires to the side, the steelcables of
the chute where supposed to cut the wooden rotorblades in the process! I
understand they sold quite a few kits!
b) As a professional helicopter pilot I urge you to abandon your fixed pitch
idea! You want to depend on a parachute that you hope you will never need,
but if you do you wonīt know if it works or not! If it works, how low can
you deploy it? On a regular helicopter I know for a fact that my rotorsystem
works and that I can change pitch anytime! I can autorotate from any
altitude even from 10ft instantly just by manipulating the controls I
already have my hands on - no need to find and activate a different
Emergency-handle!
I donīt think you are on to a pipe dream, but even though it makes it more
complicated, try to go for a adjustable pitch control. You might also check
up on Dave Jacksonīs site: http://www.synchrolite.com/UniCopter.html#Primary
You will find a HUGE amount of information about helicopters. He also was
dreaming about a coaxial design, but changed to a intermeshing one (like the
K-Max heavy lifter) for better aerodynamics and efficiency. He has a lot of
technical reference material, formulas, etc.
Whenever I start to dream about my personal design I consult his webpage!
Last, what was you reasoning FOR the ShopMaster-CNC against others?
There are quite few on the market, so to choose one is a tough call. What
spoke for the ShopMaster for you?
Thanks for your time,
Thomas Jakits
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.