Subject: Hollow shaft PSRU
From: ACRE
Date: 8/25/2003, 9:37 PM


Front and back in this 2.85:1 design as the planet housing rotates
so all prop thrust is applied to the planet housing. Tractor and pusher.

BTW I also use them to handle the helical gear thrust by putting another
couple inside the prop shaft. Since the prop shaft rotates in the same
direction as the input shaft in a 2.85 unit the RPM difference is
only about 3000 RPM extending the life of the needle thrust bearings.

Paul Lamar

Paul,
Is there any thrust loads on the prop shaft (and needle roller bearings),
other than the helical gear thrust.
In another picture you have a couple of needle roller bearings between
the shaft and the face of the planetary housing - should those be included?

This then would make:-
Two for the shaft (or even three - being two at the back and one at the
front)
- taking the radial loads

Two for the helical gear thrust (as mentioned above)
Two between the shaft and the planetary housing (outside diameter)
- or are these the same two.

One between the sun gear and the inside planetary housing
Two behind the sun gear.

George (down under)

Six total if the gear box is to be used on both tractor and pusher without
mods. I don't have a complete 3D showing all six yet but will work  one up shortly.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.