Subject: Hollow shaft psru
From: ACRE
Date: 8/26/2003, 12:56 PM


 > > Harrison,
 >
 > Here are some more pictures and illustrations for the light weight
 > hollow prop shaft that nobody has tried yet. The idea here is to
 > use the pinion shafts to connect the prop shaft directly to the
 > rotating planet carrier. This minimize the load path and eliminates
 > the cost and weight of splines. The same idea is used on the prop
 > end. The prop drive lugs are welded directly to the flared hollow prop
 > shaft. These are threaded internally for the prop clamping bolts.
 > No conventional prop shaft steel flange is used. This in theory cuts
 > the weight greatly. The prop flange (spacer, back up washer) shown
 > can be light weight aluminum as there is no load on it.
 >
 > Since you have an NC mill and you are willing to build your own PSRU
 > you are the ideal person to try this idea.
 >
 > I'll send some pictures of the planet gear set shortly so you can get
 > a feel for how small and light weight it really is.


 Paul,
 I've been thinking about the easiest way to manufacture this PSRU shaft and
 came up with the idea, which may be the easiest way, that is to Laser cut it
 out of flat Chrome Molly (or similar material) roll it, then weld it up -
 then x-ray it.

 The notches for the hollow internal threaded shafts could be done at the
 time of cut-out.

 I think you suggested 3/16" steel previously, naturally the thinner the
 material the easier it would be to roll. perhaps it could be thinner - may
 be an 1/8".

 Any comments ?
 George (down under)

1/8 inch would probably work. The FEA on the shaft did not show high
stress levels.

I guess that will work but I was thinking of hogging it out of billet
or thick wall 4130 tubing on a big NC lathe. It must be hardened and ground
as the needle bearings run directly on the prop shaft.
Ignore the deflected pinion shafts on the input end. That was a mis-
understanding on the part Dan Ruggirello's of how it worked when he did
the first FEA's.

Paul Lamar

   What material would you use on the pilot shaft, I find it flat
amazing that the spline can handle that punishment without any lube.

  Ken Welter

I am confused Ken. What do you mean by the pilot shaft? Do you mean prop shaft? I have not 
shown a spline. A spline is not really necessary anywhere in this design.
That is why the pinion shafts are an integral part of the prop shaft.
The needle bearings are lubed by engine oil fed in at low pressure the same way 
the Ross is lubed with minor improvements.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.