Edward Klepeis wrote:

Dear Paul
     In your picture of the cooling tube with your water pump is

shown  a long alum tube type bottle. Are you making these

bottles or do you have someone  making them for you.If not I make

the same bottle up for the subaru only shorter with a 16lbs

stainless steel cap.my bottles are 3'' in dia. and how ever long you

would need for your set up. Let me know if I can be of

service to you.

Regards

                                                                  Ed
                                                       tech welding

Not me I am a lousy tig welder :) Long is good. It needs a couple of

fittings

on the top for vent lines from the top of the engine. I need to add

those

into that 3D.

Paul Lamar

Dave Arbogast wrote:

Hi Paul, what flavor of welder to you have? I was looking at the Miller

180SD.

-dave
mailto:dave@arb.net
http://arb.net-

I have a Lincoln 175. It is fine but a little limited for heavy aluminum

plate.

BTW Dave and folks. Please place your message at the end of the quoted

message

and then things will be in chronological order and your signature file

will

be placed in the right place. I.E. after your message. Otherwise I have to

move

things around.

Paul Lamar

As I love equipment, and have five welding machines, I purchased
the small Lincoln invertec machine at OSH, for portability.
I also tried the Miller SD, and ended up with the Lincoln.
Check the specs on their website, an impressive little machine.
Archie

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.