> >> What material would you use on the pilot shaft, I find it flat
> >> amazing that the spline can handle that punishment without any lube.
> >>
> >> Ken Welter
> >I am confused Ken. What do you mean by the pilot shaft? Do you mean
> >prop shaft? I have not
> >shown a spline. A spline is not really necessary anywhere in this design.
> >That is why the pinion shafts are an integral part of the prop shaft.
> >The needle bearings are lubed by engine oil fed in at low pressure
> >the same way
> >the Ross is lubed with minor improvements.
> >
> >Paul Lamar
> The splined shaft that connects to the torsional damper, also what
> temper do you think it should have ?
>
> Ken
A spline is used by Tracy in that position but it is not necessary.
Here is a gif & picture of Don Dunbar's set up.
I think the minimum called out by Torrington for needle bearings is Rc 58.
Paul Lamar
I think I know what you are thinking Ken. Yes... a large hollow thin
wall shaft
with needle bearings would cut the weight of your belt drive. When
one thinks about
it...it does not make a lot of sense to go from a 12 inch pulley
down to a 2 inch
solid steel shaft and then back out to a six inch prop bolt circle.
It would also be easy to build a mechanical variable pitch prop if the
prop shaft is hollow and accessible from the back as yours would be.
BTW IMHO you should black anodize that psru. I think you would sell more.
Paul Lamar
Not thinking about it on the belt drive but on another one as I am
thinking about building a RV-9 and the belt ain't the way to go for
that bird.
Has anyone run one of those dynaflex coupling yet that you know of ?
No Don is not yet flying. Soon :)
[My PSRU]
It looked like it was black anodized after the fire until I sand
blasted it, if I get some down time I do plan on anodizing it but
just been busy turning avgas into noise lately.
Just rolled over 100 hrs on the new bird, been going to the San Juan
island nearly every weekend.
Ken
I got to get up there and go for another ride before summer is over :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.