Tom Webber wrote:

Question,  Where or how can I get my rotors apex seal slots milled to accommodate 
the 3mm apex seals?  Is this something that
can be done in the home shop or is this a milling only  
operation?  Any help is appreciated.  Thanks T.W.

Hurley Engineering in England was the originator of this idea.
I think Bruce Turrentine has somebody in NC that can also do it.

Check the web site for the Hurley link. Hurley also makes the vast majority
if not all of the 3 mm replacement apex seals.

It is best done by a grinding machine as the finish in the slot
is critical. A small mill would not have an adequate finish.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.